answersLogoWhite

0

Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the blower resister located on a 99 Nissan sentra?

The 1999 Nissan Sentra has a blower resistor in the air vents. This mechanism regulates the amount of air entering the cabin.


Where is the blower motor resistor in a 2008 Nissan sentra?

to the right of the gas peddal


Where is the blower motor resistor located on 2008 Nissan Sentra?

They are generally found close to the blower motor.


Why does your 1997 Nissan Sentra blower works only on position 4?

Defective blower motor resistor pack.


What causes an ac-heater in a Nissan Sentra to only blow on high?

you need a new blower motor resistor


I have a 2000 Nissan sentra. My blower fan switch is numbered 1 to 4 and when i turn it on it only works on number 4.?

Blower resistor switch


What do you do if your 1998 Nissan sentra blower motor only blow on high speed?

More than likely the blower motor speed resistor burned out.


Where is the blower motor resistor located on a 2001 Nissan Quest?

The 2001 Nissan Quest blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.


Where is the Blower motor on a Nissan Sentra?

The Nissan blower motor can be found in the engine compartment on the firewall. The blower motor will be on the passenger side of the firewall.


What would cause the AC blower controls not work on settings 1 - 3 only on 4 in a 1998 Nissan Sentra?

It can be a fuse or the switch itself or the resistor pack.


Location of heater blower resistor on a Nissan Serena 1996?

i am looking for the location of a heater blower resiter on a 1996 Nissan Serena


How you change the blower motor resistor in Nissan maxima 2002?

To change the blower motor resistor in a 2002 Nissan Maxima, locate the blower motor resistor under the glove compartment on the passenger side of the vehicle. There is a clip that is depressed and then the resistor will slide out. Remove both ends of the resistor and then replace with the new resistor.