0
You need to have the trans computer checked for codes. There will be a code that will lead to what is causing the no shift.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why is the gear shifter hard to shift into each gear on a 2000 intrepid?
The shift cable has failed.
Is there a way to test for engine codes using the gear shift and the key in a 1996 Dodge Intrepid?
yes tun the key from off to ignitiont that's just before it starts the engine 3 times then look at the odomiter it will give you codes
Why won't your 1993 Dodge Intrepid shift out of second gear?
Transmission is in limp mode and most likely it is the input or output sensor or a wiring problem to one of them.
What Gear Oil does a Dodge Intrepid 2001 use?
75w90.
Why transmission for a 1996 dodge transmission will not shift out of first gear?
if spedo dont work ether its a speed sensor
Why is 92 Dodge Colt hung in fourth gear?
Why is 92 Dodge Colt gear shift hung in fourth gear?
1999 Dodge Intrepid will not shift out of first gear?
AnswerTry replacing the input and output speed sensors located on the left side of the tranny and reset the computer. They will run around $40 to $50.
What is diagnosis code po731 for a 1999 dodge intrepid?
P0731 Gear I Incorrect ratio
How do you get the timing gear off the crank on a 2002 Dodge Intrepid 2.7 motor?
With a special puller.
How do you check the gear oil on your 2002 Dodge Intrepid?
i kno how 2 check your oil ;D
Cam position sensor location for 1996 Dodge Intrepid?
Cam sensor on 1996 Dodge intrepid 3.5 V6 is on the driver's side on top where the cam gear turns on the front of the engine.. Usually has a 90 deg. connector for the wires.. MUST be air gapped correctly to work proplerly.. DO NOT Bottom the sensor out against the cam gear unless the new sensor has a card board disc glued to the end of the sensor to set the gap... Good luck!
P0731 code on a 2002 Dodge Intrepid?
Trouble code p0731 means: A/T Additional Gear Ratio Error In First Gear
