Check the distributor electronic module. I had the same problem with a Mazda 626 and I changed the distributor and it runs fine since then. The electronic module overheats and does not function properly until it cools off again that is why your car will stall and after it cools off it will start again.
Whats wrong when an 86 ford aerostar keeps trying to start after the engine is running?
You give her some jungle juice then get the wheels spinnin, then hold the brake and wheels will start pourin out smoke
No.
I think the resistance value of starting winding is less than the running winding of the single phase motor
Yes. You can damage your starter bydouble starting the vehicle. It will not damage it if done only a few times and not for long periods, if you did double start once or twice, don't worry. Most newer vehicles have a bypass that will not let you double start your car.
It is important to know the symptoms of a part going bad. The signs of an ignition switch going bad is it overheating, no clicking when trying to start, the car has issues starting and running.
A starting cap is placed in circuit of the start windings only when the motor is starting and is normally of a higher capacitance than a running cap, in the region of 70 - 120 mf, where a running cap stay connected with the start windings of the motor and is normally an 8 mf cap.
Cars often stall after starting because of fuel line problems.
Starting pistol
to show that they are happy with you and other things around them
Running is a good way to reduce heart disease. If you want to ease into running you can start by walking. Any bit of exercise is vital when you are trying to reduce heart disease.
Sounds like your battery needs replacing.