answersLogoWhite

0


Best Answer

check wire routing,order, or if replace is needed, after that check compression, head gasket,or crack in head.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1998 dodge misfire replaced plugsinjectordist cap and rotor still misfire?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix obd codes 300pd 301pd302pd and 307pd on 1996 dodge 1500 v8?

Those are all misfire codes. The common cause would be spark plugs, wires, distributor cap, and rotor.


What will cause a misfire on a 2002 ram 1500 5.9 i have replaced cap rotor plugs wires and coil.?

One cause is the IAC (idle air control) solenoid. which is the most common on Chrysler products. .


Where is the distributor rotor on a 1999 dodge neon?

A Dodge Neon does not have a distributor.


How do you remove the rear brake rotor on a 2005 dodge ram 2500?

How do you remove the rear brake rotor on a 2005 Dodge Ram 2500?


98 silverado 5.7l vortec misfire on cylinder 3 sometimes?

try changing the cap and rotor


Should the brake rotors be replaced along with the pads when new pads are installed on a 2006 Dodge Sprinter 2500?

Yes, if you measure the rotor thickness, they will be under minimum spec.


How do I remove dodge rotor?

acetylene and hammer


Does 1996 dodge ram 1500 4x4 5.9l have distributor and rotor or coil pack?

Distributor and rotor.Distributor and rotor.


Where does the rotor point to when its top dead center on a dodge 318 1985?

rotor will point to #1 at TDC.


How does a 94 Z28 distributor work. Does it still have a rotor and 8 pins subject to carbon tracking...?

yes it has a cap and rotor. its just located on the front of engine a timing chain cover. it has 8 pins and can be replaced. Also rotor can be replaced.


How do you set initial timing on a 96 dodge Dakota 3.9L after timing chain and distributor have been replaced?

Crank on tdc#1. point rotor in distributor at the line on the pick up plate.Crank on tdc#1. point rotor in distributor at the line on the pick up plate.


What are causes for rough idle misfire when stopped changed wires plus gas filter rotor and cap?

Run a compression test.