answersLogoWhite

0


Best Answer
Part of Brake Light System Nonfunctional
The fact that the "third" brake light does work tells us that the much of the brake light system is good and thus working. This tells us the fuse is good, the brake light switch is working, and that the wiring to the 3rd light is good.

The fact that the 3rd light works and the brake lights at the rear don't work tells us that the specific defect causing your problem is located somewhere BETWEEN where the wires for 3rd light split off from the main harness, and split/fork for the rear brake light assemblies.

Although I'm not familiar with your vehicle, that year most, if not all, vehicle brake light systems had the main harness go to one of the rear tail light/brake light assemblies, and then "split" off with the harness continuing to the other tail-brake light.

That suggests that the OPEN CIRCUIT condition [your defect] is located in that section of the circuit between where the 3rd light wires split off from the harness, and where the harness splits for the two rear tail-brake light assemblies.

We're only talking about roughly 5 to 8 feet of wire/harness here, and that's where to look for something like a disconnected or "loose" connector plug, or a cut wire.
User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1999 Chevy Venture no brake lights Third brake light works you have changed bulbs and brake switch.?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you get the interior lights to go off on a 2001 venture Chevy van.?

there is a switch on the ceiling of the van


Why don't the brake lights work on my Chevy Venture van 2000?

If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.


Where is the relay switch for head lights located on a 1998 Chevy venture?

check the fuse box on top of the battery.


Lights behind 1999 Chevy Venture radio are out?

There may be an issue with the relay switch going to the radio lights. There may also be an issue with the fuse.


What will cause your rear signal lights to not work when the front headlamps are working on your Chevy venture?

it is most likely a fuse or at worst the turn signals and stop lights work through the turnsignal switch


2002 Cadillac STS interior lights do not come on when doors open?

I've got a better question, why is this question in the Chevy venture forum ? I think the sliding switch underneet the on/off switch for lights is fully in the left position.just slide it to the right.


Chevy G20 van you changed the rear lights to LED could this cancel the cruise control?

It shouldnt. The cruise control senses by the switch on the pedal not by the lights.


Why don't 2001 Chevy blazer brake lights work?

check the multi function switch. I hava a 96 Chevy Monte Carlo and I had the same problem . I changed the multi function switch and the brakes lights now work. the rear brake lights run thru the switch on the turn signal circuit. try it and see.


If the lights on the dash and rear tail lights went out on a 2002 Chevy Venture what fuse would this be?

#12a


Why are the reverse lights not working on Chevy S10 after bulbs are changed and fuse is okay?

switch on the transmission which sends a signal to the reverse lights when shift is in reverse......... is shot. You need a mechanic.


How do you get your reverse lights to work you have changed your safety switch and the connectors the lights work when you jump the wires but not when the switch is hooked up?

on what vehicle ? ford Chevy crosley fiat yogo ? there could be more than one switch usually the reverse light switch is located on the trans


You changed bulbs and fuses and still your brake lights do not work on your 91 S-10 Chevy Blazer?

Check the brake light switch.