My 1999 T&C XLi is easy to set the clock. There are small buttons labeled H and M that you use a pencil to push. The third row seat is removed form the rear. There are handles on the lower outer enges that are grabbed and rotated inward to release the latches. There should also be pictures and instructions on the back of the seat.
The 1999 Chrysler LHS dashboard clock fuse can be found in the fuse box. The fuse box can be found in the engine compartment. The location of the fuse will be listed on the inside cover of the fuse box.
There is no fuse listed for this clock. Remove the clock then check for DC voltage in the plug on the back of the clock. if you have power, your clocks bad, mine was . Replaced it . all's well. Hope this helps
To set the clock on a 1999 Chrysler Sebring Convertible, turn the ignition to the "ON" position without starting the engine. Press the "CLOCK" button on the radio or dashboard, and then use the "H" (hour) and "M" (minute) buttons to adjust the time. Once set, press the "CLOCK" button again to save the changes.
You have to remove the fuel tank.
from the inside of trunk
To remove the clock from the dashboard of a 1999 Vauxhall Astra, start by carefully prying off the surrounding trim panel using a flat-head screwdriver or a trim removal tool. Once the trim is removed, you should see screws securing the clock in place; remove these screws. After that, you can gently pull the clock unit out of its housing. Disconnect the electrical connector at the back to fully remove the clock.
Carefully remove the lens then bulb
It is under the dash, you have to remove entire dash to access.
Located in the oil pan
the fuel pump is in the gas tank. the tank has to be removed.
You have to remove the upper intake plenum.
No