0
What else can I help you with?
What color wires on 99 Oldsmobile alero factory radio?
go to crutchfield.com or the12volt.com
If you take out the factory radio and install a new one why the car wont start its a 1996 grand am?
o.e. radio may be part of alarm system. or, blew out fuses. may have caused electrical damage(cut wires, blown electrical components).
How do you wire an amp to a 2006 Chevy Cobalt factory radio?
To wire an amplifier to a 2006 Chevy Cobalt factory radio, you'll typically need a line-out converter to tap into the speaker wires since the factory radio doesn't have RCA outputs. First, locate the speaker wires at the back of the radio and connect the line-out converter's inputs to these wires. Then, connect the RCA outputs from the converter to the amplifier. Finally, connect the power, ground, and remote turn-on wire from the amp, making sure to follow proper safety and electrical guidelines.
How can you find out what wires go to what when replacing a Dodge Stratus factory radio with a new one?
One of the easiest and quickest ways to do this, is to go to an audio store and buy a wire harness. It should plug right into the factory plug (providing that it is still intact) and then plug into your new radio. If not, it will have ready to go wires for the harness that came with your radio.
Where is the factory Bose radio amp located in a 1987 corvette?
behind the radio hidden up amongst the bundle of wires, it is very difficult to access and replace
How do you remove the radio of a 1995 silverado?
all you have to do is take the dash off (if you pull it it comes off) the unhook the light wires and the cargo lamp wires the the radio will just unclip and you can pull it out
You need to know what the wires are for your radio in your 1993 Jeep Grand Cherokee Laredo?
the answer is here www.installdr.com I had the same problem.
Where do you find a 93 grand Cherokee radio wiring diagram?
section 12-55 in haynes repair manual has a diagram of all the radio wires and the colors.
When headlights are on why doesn't radio light up on 1994 olds delta 88?
have you checked your wires
What do you do if your aftermarket radio wiring harness does not match the factory wires?
Many aftermarket companies sell adapters for aftermarket wire harnesses. They have the original factory harness at one end and you cennect that to the harness that came with the radio. Check your local car audio installer.
ZX2 Factory Radio Has No Sound But Power?
If your are using a wire kit, you need to connect the blue and/or blue/white wire from the harness to the blue/white wire from your radio. Now if you have cut your wires you will have to locate the one wire that will turn on your factory amp.Good Luck!!!!
How do you hardwire a car stereo to a 1999 Chrysler Cirrus?
Hardwire means "physical stuff not software". It means: take the loose wires of your radio - (No factory plug on the wires) and tie it to the wires of the car radio wiring. (There are wiring kits that may adapt your vehicle to the radio if both of the radios still has it's plug $&20) You have to match and splice, or tie together all of the desired or required wires from your new radio to the vehicle radio wiring... I suggest you do not cut out the vehicle radio plug but skin the wires back a little here and there (and tape up afterwards) to get a connction you need and solder the radio's leads to the vehicle wiring just behind the original's radio plug. LOL
