0
1 brake light works other one quit fuses good third brake light wworks bulbs good 1988 olds cutlass supreme?
Wiki User
∙ 14y ago
its the blinker control arm.if you move it back and forth you should see the two other brake lights go on as the brake is pressed.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the rear license plate bulb on a 1996 Olds Cutlass Supreme?
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
Why does only one brake come on on a 1990 cutlass and not the other just blinks third brake light out too checked fuses and bulbs?
My 1991 Olds Cutlass Ciera had that problem and it was corrected by replacing the turn signal switch. Troubleshooting with the factory service manual pinpointed the problem. Paul S
Your brake lights work when you brake not when you turn lights on?
AnswerThe bulbs for the brake lights are usually separate from the normal tail light bulbs. Check and replace the brake bulbs first, and if they are still not working examine the fuses, switch and wiring.
Why do my brake lights not work on 1992 Oldsmobile cutlass?
Brake light failure happens from a variety of problems, such as burned out bulbs, a short in the headlight wiring or a blown fuse. You can tell if the bulbs are out by a rapidly blinking turn indicator, a blown fuse by checking the fuse is the panel on the side of the dash, and check if its a short circuit by using a volt reader in the light socket.
What color are brake lights?
Brake Light ColorMine are clear bulbs ["white"] light, but the bulbs are mounted in an assembly with a red lens.
What color are your brake lights?
Brake Light ColorMine are clear bulbs ["white"] light, but the bulbs are mounted in an assembly with a red lens.
Why brake light in rear window come on but brake lights dont on 89 Nissan Sentra bulbs are fine and brake light switch has been changed?
check your bulbs
Why does your 2003 Ford Explorer's brake lights not work but the bulbs and fuses are fine?
If the bulbs and fuses are fine, it must be your brake light switch attached to the arm on your brake pedal.
How do you change the brake lights on an Oldsmobile cutlass 1998?
Open trunk and pull carpeting back from the rear lights and you will see wing nuts, take the wing nuts off and pull the complete light assembly out to change the bulbs.
What brake and tail light bulbs go in a 1994 Chevy truck?
The # is 1157 bulbs.
How is the drivers side brake light bulb accessed on a 1998 Olds Cutlass?
Not sure on this particuliar vehicle but on most newer vehicles the tail light bulbs can be accessed by opening the rear door or trunk and removing a panel that allows access to the tail lights and the bulbs. If this is not possible you should have some type of screws on the tail light lenses itself that can be removed to access the bulbs. , EzForJesus
What do you do if your tail lights do not work while driving though brake lights work fuses and bulbs are good?
on some cars the tail lights and brake lights are totally different bulbs gain access to the bulbs and have someone push the brakes so that you can determine which bulbs are the brake lights and replace the tail lights
