Regretfully no there is no just cover or lens replacement. the whole healight assembly must be replaced. If somehow you do find a lens cover, then you will have to find a way to unglue the old cover without damaging the base and then reglue on the new cover with no air leaks so that water cannot get in and damge all of the electrical connections on the inside of the headlight assembly. Good luck to you
Go to Ebay. They have replacement antennas cheap, with the cover attached.
REMOVE TWO TOP BOLTS ON HEADLAMP ASSY. THEN REMOVE BUMPER COVER, THATS RIGHT THE BUMPER COVER, THEN REMOVE TWO BOTTOM BOLTS
the head light cover does not come off but if you pull up on the two plastic clips on the back of the radiator support the whole headlamp assembly willcome out. gm Jim
To change the headlamp on a 2000 Plymouth Breeze, first, open the hood and locate the headlamp assembly. Disconnect the electrical connector from the back of the headlamp by pressing the tab and pulling it off. Remove the retaining clips or screws securing the headlamp assembly, then carefully pull the assembly out. Replace the old bulb with a new one, reassemble everything in reverse order, and test the new headlamp.
How can I replace the headlamp on a 2000 Saturn SL1
To remove the headlamp assembly on a 2000 Toyota Solara, start by opening the hood and locating the headlamp assembly. Remove the screws or bolts securing the assembly, typically found on the top and side of the unit. Disconnect the electrical connectors and gently pull the headlamp assembly out of its housing. Be cautious not to damage any clips or wiring during the process.
Look in your owners manual. There are three bolts to remove the headlamp. Once you do this you will able to access the pannel on the back of it that will allow you to change your headlights
In a 2000 Nissan Quest, the headlamp relay is typically located in the engine compartment fuse box. To access it, open the hood and find the fuse box near the battery. The relay itself will be labeled, so you can identify it by referring to the diagram on the underside of the fuse box cover. If you're having trouble locating it, consulting the vehicle's service manual can provide additional guidance.
seems to be a common problem on this vehicle. I have a 2000 Montana and I have had to replace the complete headlamp assembly because there were cracks that let water in the headlight bucket. I have also seen the lens actually pull away from the whole assembly as well. The last time I replaced a headlamp assembly, I made sure I covered the lens to assembly gap with clear silicon, seems to be doing the trick so far.
Open hood, remove headlamp bulb from headlamp assembly, remove (1) 10mm bolt from top of headlamp assembly, next remove (3) 10mm bolts from behind headlamp assembly, pull headlamp forward ( you may have to pry gently from the right side). Remove turn signal bulb-Done!
To remove the headlamp assembly from a 2000 Mercedes SLK230, first disconnect the battery to ensure safety. Open the hood and locate the retaining screws or bolts securing the headlamp assembly, typically found at the top and side. Remove these fasteners, then gently pull the headlamp assembly forward to detach it from the vehicle. Finally, disconnect the wiring harness from the back of the assembly before fully removing it.
The Replacement was created on 2000-10-10.