You should not need to remove the main bearing cap, in order to replace the rear main seal. The rear main seal will come off without touching the main bearing cap.
to remove the spindle and four bolts hold the bearing assembly to the "A" frame. remove the wheel, remove the control arm, remove the lower "A" frame , and remove the CV axle. then you will have acess to the 4 bolts that hold the bearing assembly. you will have to buy the whole assembly.
To change wheel cylinder on a 2000 Chevy Malibu, jack up the vehicle and remove the tires, brake drums and brake shoes. Spray the hydraulic line and fitting with CRC 5-56 and loosen hydraulic fitting. Remove the two mounting bolts and remove the wheel cylinder. Replace with new.
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing retaining nut. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
Remove wheel then remove the big nut that holds the axle to the hub. Remove the brake caliper and rotor, through the hole in the face of the hub(where the wheel studs are) remove bolts that hold the hub and bearing to the steering knuckle. Tap hub and bearing assy from knuckle. The hub and bearing is one part.
You can change the cylinder in your 2000 Chrysler Town n County by removing the head. Remove rod bolts from the crank. Push the cylinder out. Reverse the process to install the new cylinder.
You cannot change the compressor bearing, however, you can change the clutch bearing. Which one is bad? Is there a noise when the clutch is engaged, or not engaged?
how to remove a door lock cylinder on 2000 dodge neon
To remove the ignition cylinder on a 2000 Lexus RX300, first remove the vanity engine cover by unscrewing it. Disconnect the wiring connector by pushing the clip that holds it in place. Finally, remove the bolts that hold the ignition cylinder.
You have to remove the tire then remove the brake caliper and bracket then you will remove center greese cap and remove the carter pin and remove the will nut lock nut and washer jar the rotar to remove the outer bearing it might be tight due to a greese seal. Once the bearing is removed slide the rotar off.
Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing). Reverse to install Take off belt, remove bolt in center of pulley, replace with new pulley (comes with bearing).
Loosen the hose clamps on each end of the big square air box and remove it. Then you can release the clamps on the air cleaner box, remove the lid, and remove the filter.
Remove the retaining ring from the top of your 2000 Mercedes-Benz ignition lock cylinder. Slide the ignition lock cylinder out and remove the wiring harness.