its the DPFE sensor....39.99 at autozone....about 20 minutes to replace...
replace the sensor.
12 means that the battery was recently disconnected or lost voltage. 22 means that Engine Coolant Sensor is out of normal range (replace the coolant sensor).
An engine coolant temperature sensor will usually need to be replaced when it is drawing too much or too little voltage. The sensor may also have a bad ground connection.
you have either a bad speed sensor (check engine light on?) or a short in the printed panel and amp/ voltage reg. on the back of the speedo head. no check engine light on replace/ rebuild speedo head there are speedo shops. if light is on replace speed sensor as the OBD system uses this sensor to. clear codes and happy driving Johnie
tell me how to replace my engine temp sensor
The coolant temperature sensor can be found on the front of the engine, near the thermostat. Remove the coolant temperature sensor retaining nut, to replace it.
Trouble code P0132 means: O2 Circuit High Voltage (Bank 1, Sensor 1) Replace the upstream O2 sensor (cylinder 1 side)
That is a MAP sensor code, check to see if the sensor is returning at least .5 volts, if not check for 5 volt reference voltage on the connector. If you have voltage going in, and none or less coming back out replace the sensor, if no reference voltage check the connectors, wiggle them and monitor the voltage. If the wiggle test checks out, draw a vacuum on the MAP sensor vacuum port. As you add vacuum the voltage should decrease. With no vacuum, the MAP sensor should read around 4.5 volts. If there is no change in MAP sensor reading on the scan tool, replace MAP sensor.
replace the bad sensor and it will turn off.
You need a engine scanner and hook it up and it will tell you what sensor is bad.
Yes, replace the sensor and have the dash light reset.
The computer is not seeing a voltage drop across the coolant sensor. You could have a bad sensor, broken wiring, or a bad computer.