0
if you had the pedal to the floor for a long period of time (hard rapid accelerating for more than 30 seconds) it will trip your o2 sensor in the sebring. it is because the fuel injectors are told to hold wide open and that trips a fault in the computer that makes it believe that your oxygen sensor is going bad
What else can I help you with?
How do you reset the check engine light in a 2002 Chrysler sebring convertible?
You need a scan tool to properly reset the check engine light.
Check engine light on 2004 sebring what does it look like?
It looks like a little yellow engine.
Why is the Check engine light on in a 1998 Chrysler Sebring?
The engine light stays on when the engine computer has detected an emissions related failure and set a code.
Service engine soon light is on on 1997 Chrysler sebring convwhat needs done?
Have it checked for codes, That is the same as the check engine light.
How do you reset the light check engine on 2000 sebring conv?
unplug the battery for 30 seconds.
How do you reset the check engine light on a chrysler sebring?
A local auto supply store can reset it for you.
How do you reset the check engine light on a 2008 Chrysler Sebring?
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
Why Check engine light flashes while driving and car hesitates for a bit then light goes out any suggestions?
engine is about to stall
How do you reset check engine light in 2001 Chrysler sebring?
The only proper way is with a scan tool.
What are signs of a belt jumping time on a 2003 Chrysler Sebring?
Check engine light, low power, no start, runs rough, bent valves,Check engine light, low power, no start, runs rough, bent valves,
How do you reset the check engine light on a 1998 Chrysler Sebring convertible?
You can use a scan tool or unhook the battery after repairing the cause of the fault.
Warning light on 2002 sebring car show an engine?
It is your "check engine" light. It is telling you that something is wrong with the engine or engine controls. It could be minor or major. You will need to get the "codes" read to find out the problem. Use a code scanner to find out what is wrong.
