Power is not being supplied to the clock when the car is turned off. It could be a blown fuse.
on 1998 Camry turn key on push and release alarm button turn key off then start
To set the clock: 1. Push the "SELECT" button and "RESET" button together for at least two seconds. 2. When the hour digits start flashing, push the "RESET" button to set the hour. 3. Push the "SELECT" button, and the minutes digits will start flashing. 4. Push the "RESET" button to set the minutes. 5. Push the "SELECT" button and then release it to start the clock.
no. you might have to reset the clock and radio.
press both buttons at the same time, it will start blinking, set it then.
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
This is how to reset "Maintenance Required" light on Toyota Camry with "Smart Key" feature.This works on 2007 and newer Camry models, including the Camry Hybrid. Put the odometer on "Trip A." Turn off the car, hold down the odometer button and, without putting foot on the brake, push "Start" button twice (while continuing to hold down the odometer button). Watch the display . . . it will speak for itself.
Just push in the clock adjuster and start engine hold down for 12 seconds it will clear
always 8 o clock on channel teennick or 133 if u have comcast
Most likely because your anti-theft system was not reset. It must be done.
if you have a GM product without the information display, turn the ignition to the run position do not start the engine. push the accelerator pedal all the way to the floor three times. it will take a few seconds to reset watch the big square red light on the dash when it changes from yellow back to red the oil change clock has been reset
hold down the trip reset button for about 10 seconds then the minute hand should start moving
Yes