on back of engine behind the flex plate.
That year model does not have a crank sensor.
They did not use a crank sensor in 1984, There was no need for 1
behind the starter
at the rear of the engine on 2001 2.L also
i have a 2001 Chevy tracker and i just replaced the crank sensor. i have been having a problem with mine not cranking. i would drive it and cut it off. it would not crank up until after it sat for a while. the crank sensor has not fixed the problem though. you have to take the tranmission out and take the flywheel off. the sensor is behind it. hopes this helps. i got a sensor at napa for about $100. advance auto parts wanted about $174 for it i think
The crank sensor on the 2.0 DOHC engine is behind the flywheel (flex plate) on the back of the motor. In order to change it you must pull the transmission or motor.
where is the crank sensor located on a 2005 chevy impala
You must know the engine, such as 4.2liter
ON the side of the motor behind the starter.
when my camshaft sensor was going bad, the vehicle refused to crank after being driven and parked for a few minutes. If you wait a little while it may crank. I heard of people pouring water on the sensor casing to crank them also.
Under the car in the back of the motor.8mm bolt holds it in
there isn't one