metric - before you go there back off on the adjuster and soak the stud holes and axle hole with WD-40
Removing a door panel on a 1999 Chrysler 300 M series is simple to do. First the speaker grill will need to be removed by taking out the two screws, then the 9 screws will be taken out holding the door panel in place. After the screws are out, the door panel can be removed by gently pulling on it.
take out the screws on the inside
20680
2 screws, up/down. left/right
T30, 2 of them
Remove the glove box then the four (4) hex screws on the blower motor cover. Then remove the mounting screws for the blower motor and set it down on the floor - it should have enough length in the wiring. Disconnect the the wiring connector them remove the rubber grommet and wiring harness through the blower housing. Installation is the reverse of removal. Good luck!
easy fix, only two screws
There are two screws on the the door panel.
Remove all screws and it should pop right off.
If the oil pump screws are starting to strip during the removal process on a 2000 Toyota Tacoma 2.7 liter, the hole will need to be repaired. A Helicoil insert can be put into the hole to replace the damaged threads along with new screws.
It screws into the top of the rear exhaust manifold.
Remove the four torx screws in the lower housing