how can i reset rear brake pad warning light on 2006 bmw 525i
How do you reset the oil service warning light manually on a 2003 BMW 525i?
how i rem placing 2004 BMW 525i solenoid vanos unit.? because my car no change in 4 and 5 speed
To reset the increased emission light on a 2004 BMW 525i, you typically need to use an OBD-II scanner to clear the diagnostic trouble codes (DTCs). Alternatively, you can disconnect the battery for about 15 minutes, then reconnect it, which may also reset the light. However, it’s essential to first address any underlying issues that triggered the warning light before resetting it. Always consult your owner's manual or a professional if you're unsure.
I have same problem on 1994 525i. Need a new control module which no one seems to have.
The brake lights on a 2001 BMW 525i are replaced by removing the retaining screws, pulling the light assembly from the vehicle, and disconnecting the bulb. A new bulb is then put in place and reassembled.
replace the light module
The 2004 BMW 525i came equipped with the 2.5L 6-cylinder engine. The vehicle requires 0W40 or 5W40 European specification synthetic engine oil. The most current specification for these oils will list BMW Longlife-04 on the bottle.
You will need a compatible BMW scan tool to reset this service light from the I drive system.
You need two special BMW reset tools.
You will need a compatible BMW scan tool to reset this service light from the I drive system.
http://www.unofficialbmw.com/e36/electrical/e36_reset_service_lights.html Here lies your answer