i need help also
filter on Nissan fronterAnswerOn the 2wd frontier if you slide under the truck from the front(after removing plastic under guard) it is located on the right front part of the motor. It is small and can be a little difficult to see.
(96+) Front of the engine, drivers side, remove splash guard below front bumper
Its on the passenger side of the car. It comes out of the bottom. There is a small splash guard covering it. The A/C belt has to come off before the alternator belt. Have fun! Have you tried opening the hood?????????
at the front o/s wing! you will need to remove the plastic wheel arch guard to get to it.
Pull the push pin out. This loosens the plastic guard surrounded the headlight. Pull the guard off. This allows you to remove the headlight assembly.
The water pump is located on the passenger side of the engine block-- at the bottom. To get to it you need to remove the passenger side wheel, the plastic splash guard, etc. It's tough to get to. Here's a link that shows how it's replaced: http://forums.maxima.org/showthread.php?t=308680 This is a great site for lots of other misc Max stuff, too.
under the engine in the front. you have to lift the car AND then remove the plastic guard in order to see the oil filter.
But where is the FUEL filter located? The oil filter is located on the bottom front of the engine midway between the two front wheels. There is a black plastic guard located under the radiator remove three of the five screws and look up under the black plastic guard. It will be pointing directly at you.
Behind the front passenger side fender/bumper. Remove the front passenger wheel, the then plastic wheel well guard starting with under the front bumper. It is easily accessible from there.
A guard in front of a club, usually a night club, is called a bouncer.
Driver side under car you have to remove plastic splash guard in order to see it, it sit right in front of the transmission, once you remove the splash guard you will see the wire going to it from the battery
On the drivers side lower front of the engine. You have to remove the plastic splash guard from under the front of the vehicle and use a 12mm socket on a 12 inch extension to get to the 3 housing bolts.