Yes, 220 and 240 volts are a nominal figure in the same voltage range. It is brought about by the power company, as they have a responsibility to keep voltages within a certain 10% range. The load will only notice a difference of 1% on the load current. e.g. Wattage load of 2400. Amps = watts/volts. 2400/240V = 10 amps. 2400/220V = 10.9 amps. On a constant resistance as the voltage goes lower, the current goes higher and vice versa as the voltage goes higher, the current goes lower.
Yes it can. It is within the normal voltage / HZ tolerance.
Yes, the 265 volts is just the maximum the appliance can handle. You can use it on a 240 volt circuit.
This is a special purpose outlet, likely for a dryer. Normally in a house electric panel you have 120 VAC as the normal and 220 or 240 as a higher voltage. The 30 A is for 30 Amps. You can only plug in an appliance that has those ratings. You can't plug in a 120 V device.
Different plugs are designed so that you can't plug an appliance into the wrong voltage. A dryer is usually 220-240 Volts and your standard outlet is 110-120 Volts. You can't do what you suggest.
Wire is wire - is doesn't matter what voltage you use. However, if you are changing the voltage on a device from 240 to 120, given the same power requirement, you may need bigger wires for the doubled current (and increased heat of resistivity).
If the appliance is 220 volt 60 Htz, yes it will work perfectly in the U.S. plugged into a 240 volt outlet.
Yes, in fact all of North America.
Yes. As far as in the US 220v and 240v is pretty much the same thing. People call it 220 but realistically you prob have 230-240v. Get a cheap voltage tester and check it out
Yes it can. It is within the normal voltage / HZ tolerance.
Yes, if the appliance was designed to run on 210 to 240 volts.
No, sorry but you fried it. Any voltage higher than an appliance is rated will do major damage.
Yes, the 265 volts is just the maximum the appliance can handle. You can use it on a 240 volt circuit.
This is a special purpose outlet, likely for a dryer. Normally in a house electric panel you have 120 VAC as the normal and 220 or 240 as a higher voltage. The 30 A is for 30 Amps. You can only plug in an appliance that has those ratings. You can't plug in a 120 V device.
Different plugs are designed so that you can't plug an appliance into the wrong voltage. A dryer is usually 220-240 Volts and your standard outlet is 110-120 Volts. You can't do what you suggest.
Yes, 240 volts is a "nominal" figure, related to peak current. The actual usable voltage is in the 220 -230 range and any 220-230 volt appliance will be quite happy.
Yes, it can. But e.g. a light bulb will have a shorter living time.
It should work with no problems, since the frequency does not affect the work or the iron heater.