You need to go to an Auto Parts Store and have them look it up. It's usually a special wrench used only for the brakes. Hope this helps.
no, it is optional
Loosen the 2 screws holding the distributor on and turn it left or right depending on the needed adjustment.
I just did my 2005 Ford Escape front brakes and the caliper was 7mm Allen and main holder is 18mm ...RRR Wis.'
9mm
Unnecessary, not needed, optional
What kind of wrench is needed to loosen the oil filter in a Mercedes Benz ml?"
They could simply, just be really hard to move it sounds like you have everything off to me, I've changed my own everytime. Try a little WD-40 to loosen it up. golf 1999, my rear calipers needed to be turnt in not pushed in if that makes sense. you need to twist them in with some big grips. not sure what way. they were tight. needed to loosten fluid cap too to help.
18 mm I think.
More detail is needed . Do you mean disc pads, or pads and rotors, or calipers with pads and rotors, or completely new calipers, brakelines and master cylinder. -All of these are viable but different options.-You need to be MUCH more specific in what you want.More detail is needed . Do you mean disc pads, or pads and rotors, or calipers with pads and rotors, or completely new calipers, brakelines and master cylinder. -All of these are viable but different options.-You need to be MUCH more specific in what you want.
Optional, it is entirely up to you.
Torx T 40 socket
HI I just replaced the rear calipers on my 99 wj which is the same as the 2002 model. Jack up the rear wheel, put in a 3 ton jack stand. 1 Loosen up the caliper brake hose fitting with a 14 mm scoket 2 Get a 45T torque star wench bit and insert in from the rear caliper pins and loosen 3 remove the calipers pins 4 loosen the caliper brake line hoise and remove , replace the copper gaskets - should come with reman calipers 5 hadn tighten the brake hose line 6 put in new pads if needed / new brake braket if needed 7 grease and hand tighten the caliper pins 8 using torque wrench tighten the caipler pins to 25 ft lbs / brake line hose bolt to 23 ft lbs. 9 replace wheel test drive.