Headlights Tail and Brake Lights
Chevy S-10

93 S-10 pickup brake light stays on?

293031

Top Answer
User Avatar
Wiki User
Answered
2010-01-06 03:18:35
2010-01-06 03:18:35

brake light switch is broken or out of adjustment. brake light switch is located above brake pedal.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Defective or misadjusted, brake light switch.

The brake indicator light is for the EMERGENCY break, release this break.

If a 1991 Chevrolet S10 Blazer warning brake light always stays on, it could just be a malfunction of the light. To reset it, disconnect the battery for 10 minutes.

Mine is on also and also the brake light, they say the abs speed sensors are bad, I will let you know

The brake light switch located above the brake pedal is broken or out of adjustment.

where is the drake light switch on a 1999 chevy s10. The brake light switch is located just above the brake pedal. You will need a flashlight to see it.

Day Light Running Lights.

Brake light switch out of adjustment or defective

Usually this indicates a problem with the anti-lock brake system. The brake system should still work (as long as the BRAKE light doesn't illuminate), however the brakes may lock up, since the ABS system may not be functioning correctly.

I don't think you can. I've been looking for the same thing for about 3 years. I have not been able to find anything. Sorry.

Above the brake pedal where the master cylinder is attached to the brake pedal assembly.

Under dash, drivers side, above parking brake.

With engine off--pump brake until all vacuum is exhausted With foot on brake start vehicle--brake pedal should drop

how do you change the oil pump on a 1991 s10 pickup

where do i put coolant in for 1994 Chevy s10 pickup

The payload for the 1985 Chevy S10 pickup is between 1000 and 1500 pounds depending on the exact model. The S10 is the smallest of the Chevrolet pickup series.

Open the tail gate, remove two small screws that hold the tail light assembly in place, wiggle the tail light assembly out, twist out socket and replace the bulb.

Probably a misadjusted or defective brake light switch.

Will a Chevy blazer engine fit in a Chevy s10 pickup

Check the bulbs, Check the fuse, Check the brake light switch, in that order.

Check the fuse, then the bulbs, then the brake light switch.

Check your battery for loose connections and check your alternator.

There are pages and pages and items that can cause a check engine light. You need to have it checked for codes with a scan tool. After repair light can be shut off with scan tool.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.