check to make sure fuel pump is working. then check to see if fuel is getting to the fuel rail, then check for spark, if you have spark, compression and fuel it should run.
There is no reset switch. The fuel system is computer controlled through relays.
No reset switch on a Jeep. The fuel pump is computer controlled with relays.
Jeep does not use inertia switches. The fuel system is computer controlled with relays.
Latching relays have no default position and remain in their last position when the drive current stops.
Main relays are located in the engine compartment fuse panel
Jeep doesn't use inertia switches. The fuel system is computer controlled with relays
Jeep does not use inertia/reset switches. The fuel system is computer controlled with relays.
Jeep does not use inertia/reset switches. The fuel system is computer controlled with relays.
On the top of the back window position in the middle .
If you have replaced the relays in your 1997 Toyota RAV 4, the engine cooling fan may not come on when it is supposed to because of a failure in the wiring, the thermostat that sends to the fan, or the fuse for the cooling system.
First thing to check is that you check engine light comes on when the key is turned on. This is simple indication that your ignition circuit is powering up the computer. Then check that the fuel pump and automatic shutdown relays are working. If you lift the hood the relays are located in front of the battery in the power distribution box with a number of fuses. Check all the fuses in the box as well as all the fuses under the dash.
Check the fuses and relays.