It is most likely the tail fuse. The dash and tail lights are usually on the same circuit
The flasher for the turn signals and hazard lights on a 1995 Eagle Summit wagon is located in the dash on the driver's side of the vehicle. It is just above the brake pedal.
Its the fuse and if not its the fuse Boxs. by the cluch or brake peddle.
the hazard lights and turn signals are linked together. make sure your signal arm is entirely linked up to all of the wires it should be. make sure no wires fell down that you didn't notice when the turn signal switch was pulled. you can also check the hazard switch.
I would first check and see if your brake lights come on when you depress your brake pedal. If not, the problem is your brake light sensor located under the pedal. These allow you to switch out of park (which is why you have to push the brake to do so). It's common for them to go out.
The dashboard lights on a 1997 Eagle Talon can be changed by reaching up into the dash to get to the bulbs. Another way is to remove the dashboard screws and remove the front of the instrument panel.
It is located above the brake pedal.
In the master cylinder usually located at the driver's side firewall attached to the brake booster unit - in line with the upper end of the brake pedal
On the firewall next to the brake master cylinder.
There are no 1991 AMC Eagles, you must mean 1981 AMC Eagle. Stalling can be caused by many things but more than likely it is a carburetor problem.
There are a lot of interesting facts on the Martial eagle. Here's a few of them: It is the largest eagle in Africa. It has enough strength in one leg to brake a man's arm. It can knock a man over. It lays only one egg every two years.
Pictures and diagrams cannot be displayed on wikianswers
You would put it in your clutch master cylinder, not your brake master cylinder. Most are located on the firewall under the hood on the drivers side.