On the firewall next to the brake master cylinder.
You would put it in your clutch master cylinder, not your brake master cylinder. Most are located on the firewall under the hood on the drivers side.
The hydraulic clutch reservoir should be located near the master cylinder on the driver's side if it has one. It is very small about 2-3 inches in diameter.
Not necessarily, it could be a number of things, master cylinder, slave cylinder, air in the lines, clutch ( has a new clutch, master, and slave cylinder btw) and multiple other things ---- well i dont exactaly get what youre saying here if you mean you start the car and it wont go into gear that a bad klutch
if it is a manual talon could be clutch not disengaging( slave or master cylinder most likely culprit) if automatic, could be something to do with tranny itself or shifter
In the master cylinder usually located at the driver's side firewall attached to the brake booster unit - in line with the upper end of the brake pedal
There is a diagram under the hood that shows you where all the fill points are located. The clutch fill is located next to the brake fluid on the driver side firewall.
If you have already checked the brake fluid levels, you'll have to replace the master cylinder.
Mounted on the firewall near the battery its a black cylinder
http://www.vfaq.com/mods/clutch-1G.html
Brake fluid is in resevior on master cylinder. Look in engine compartment on firewall just in front of steering wheel. The brake booster is a large round drum and the master cylinder is attached to it. Use a flat screwdriver to slide the two clips off the flat lid. remove lid to add fluid as needed, but remember brake fluid will remove paint, so be careful.
The number 1 cylinder is the cylinder to the right when you open the hood.
Its on the oil filter housing. About a 1 inch cylinder, with a single wire coming off of it.