answersLogoWhite

0


Best Answer

The Dipstick tube is held in place by 1 bolt. Remove that bolt, pull the tube, insert new one, install bolt.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 96 4.3l 2wd Chevy Cheyenne transmission dipstick holder broke off half way what can you do to replace it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the transmission fluid added in a 1989 Mitsubishi Mighty Max?

You can add transmission fluid to your 1989 Mitsubishi transmission through the dipstick holder. The dipstick holder should have a bright yellow handle.


How do you refill the transmission fluid on a 1972 Chevy Nova?

Pull the dipstick handle out of it's holder and get a funnel that fits into the dipstick hole and fill it.


How do you replace trans fluid 1999 3100 v-6 olds cutlass?

To replace the transmission fluid in the 1999 3100 V-6 Olds Cutlass, first remove the transmission drain plug from the underside of the vehicle. Drain all of the old fluid. Then, replace the drain plug and add new fluid through the transmission dipstick holder in the engine compartment.


Where is the transmission fluid holder for the 1999 Camry at?

Transmission fluid holder? the only place you should be putting transmission fluid is in the transmission. You add it through the same tube that holds your dipstick. Check it warm and add a quart at a time using a funnel.


Where do you add transmission fluid to a 1969 mustang?

You can add transmission fluid to your 1969 Mustang transmission through the dipstick holder. Using a funnel will make the job easier.


Why does the dipstick pops out of its holder and you smell tranny fluid on your 2003 subaru baja?

The transmission vent is plugged with debris.


How do you add transmission fluid to a Chevrolet 350 vortec engine?

You should never add transmission fluid to a Chevrolet 350 engine. You can add transmission fluid to the transmission through the transmission dipstick holder.


Where do you add transmission fluid on a 2003 Chrysler PT Cruiser?

You can add transmission fluid to your 2003 Chrysler through the transmission fluid dipstick holder. It is best to use a funnel to prevent spilling the transmission fluid.


How do you replace cup holder on 2000 Lexus es300?

How do you replace cup holder in a 2000 Lexus ES300


Where is the transmission fluid dipstick on 1999 deville?

I have a 1999 DeVille and the dip stick for the auto Transmission is located on the drivers side, under the air filter. You must remove the air filter and the holder in order to get to the transmission dip stick. You can add fluid here, but that is about all you can do. The transmission is sealed and you have to take it to a service provider and have the fluid and filter changed. That is not necessary until you reach 100,000 miles, unless your have problems with your transmission.


Where do you fill the transfluid in a 97 Cavalier 2.4 engine automatic tran od?

So you've checked the fluid level by pulling the dipstick out of the dipstick holder? Well, just add new fluid right in the dipstick holder. *****!!!!!!!DON'T OVERFILL IT!!!!!***** There will be a MAX mark on the dipstick, and it is JUST AS IMPORTANT as the low mark. Seriously. It's a pain in the butt to bleed off excess fluid too so just don't overfill it. ^^^ I'm assuming since u have the 2.4 auto it is the 4 speed with OD. it should be the 4t40 tranny, and there is no dip stick on the transmission, just a fill cap.. BUT i do know there is a small bolt that u take out of the transmission when filling, and when it's high enough, it leaks out of the hole... BUT i do not know where it is exatally, but there for sure shouldn't be a dip stick... just the bolt in the side of the transmission, do a Google search and u may find where the bolt is located u need to remove when u fill it... according to a 97 cavi's owners manual you are not supposed to have to fill the auto trans fluid UNLESS there is a leak in the system. There is a small dipstick located oh the transmission it will be on the drivers side of the engine bay all the way down on the trans it is kinda hard to get to but it does have makings for full and Low


How do you replace the in dash cup holder on a 1999 Lumina?

The front dash holder in the 1999 Lumina is screwed into the backside of the dash. Go through the glovebox to loosen the screws to replace.