answersLogoWhite

0

Under the hood on the drivers side behind the battery on the fender under the brace.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the location of the ignition control module for a 1992 cutlass ciera?

Under the coilpacks


What is code 42 on a olds cutlass ciera?

Code 42 on an Oldsmobile Cutlass Ciera means you have a faulty ignition control module. You should inspect all electrical connectors to ensure they are tight.


Where is the ecm in a 1988 olds cutlass ciera?

The Electronic Control Module (ECM) is located under the right hand side of the instrument panel.


How do you replace the turn signal windshield wiper cruise control arm on a 1987 Olds Ciera?

This is not easy since the cruise cont wires go down through the steering column. I suggest you take it to the garage.


Where is the ignition control module located on a 1996 Oldsmobile Ciera?

On a 1996 Oldsmobile Ciera, the ignition control module is typically located on the engine block, near the ignition coil. It is often mounted on the front of the engine, close to the intake manifold. To access it, you may need to remove any engine covers or components that obstruct the area. Always consult the vehicle's service manual for specific details and diagrams.


1987 Oldsmobile cutlass ciera oxygen sensor location?

what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6


Why would an Oldsmobile Cutlass Ciera stall when the brake is pressed?

it will be either the o2 sensor or the idle air control module. i had the same problem in 2 different cieras and each one had this problem.


Where exactly is the control module for the cruise control and abs system located under the dash of a 1995 V6 Olds CS SL Is it nearly impossible to get to it?

i have a 1996 olds ciera sl and i found the fuse box that controls everything from the abs brakes to the windshield wipers. what u need to do is open the glove compartment, and on the left shud be a small compartmenty that u can open, it should say fuse on it or a varation of it, open it, and it should be right there


Your car is 1991 Oldsmobile cutlass ciera 3.3l fi ohv and it stopped runnig with no worning just shut off when you were driving it it getting gas its just turns over?

This could be ecm (electronic control module) problem.


Where is the location of the sensor that controls the acceleration on a 1996 ciera Oldsmobile?

In a 1996 Oldsmobile Ciera, the sensor that controls acceleration is typically part of the throttle position sensor (TPS), which is located on the throttle body. The TPS monitors the position of the throttle plate and sends this information to the engine control module (ECM) to adjust fuel delivery and timing for optimal acceleration. If you're looking for a specific sensor related to acceleration, it may also refer to the vehicle's speed sensor, which is usually located on the transmission.


Where is obd port on 95 olds ciera?

On the bottom side of the steering column inside the car, roughly at the level where the top of the seat is


Where is the pcm on a 1990 Oldsmobile cutlass ciera?

The Powertrain Control Module (PCM) on a 1990 Oldsmobile Cutlass Ciera is typically located under the dashboard, to the left of the steering column. It may be mounted on the firewall or behind the glove compartment. Accessing it may require removing panels or the glove box for easier reach. Always consult the vehicle's service manual for specific instructions.