on the end of the pass side axle is a gear that engages the 4-wheel drive a slider like a manual tran sync slider engages it when the cable pulls on it. the gear get burr and stop the slider from sliding off.you can pull the tube off and grind burrs off or replace. it is held on with a snap ring on back side of gear.parts diagram call part " connector" part #9
This is so weird i have the same issue. It doesnt grind bad very slightly at times you have to pay attentsion to it. The person who responded to the question can you further explain this please. Thanks
Bad right front wheel bearing.
abrasion
abrasion
Abrasion
Abrasion
Abrasion
Abrasion
It sounds like the auto hub's are not disengaging. Check the vacuum line on the front axle
mechanical weathering
The dentist continued grindind away at the sharpened edge of the tooth
mainly surface grinding machines, for processing flat surfaces To improve the roughness of the processing surface grinding away a few wires to facilitate assembly If you are interested in grinding machines, you can go to VIDO's official website to check, VIDO's grinding machines are of high quality and are the choice of the public.
You may very likely have bent the thin metal backing plate behind the brake rotor. That will cause the backing plate to rub against the rotor and make an awful grinding noise. Its not too hard to reform the backing plate away from the rotor.