0
What else can I help you with?
How do you replace 1990 Jeep Grand Cherokee knock sensor 6 cylinder?
The Jeep Grand Cherokee didn't exist until 1993.
Location of knock sensor on 2002 Pontiac grand prix?
location knock sensor 2002 pontiac grand prix gt 3.8 engine
What causes the engine to knock on a 1997 Grand AM?
bad bain bering
Where is the knock sensor on a 1994 Jeep Cherokee Sport 4.0?
There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.
How do you adjust rocker arms in a 2000 Jeep grand Cherokee 4.0 motor?
if it has a knock that is not the issue, cooling fan relay goes bad, they run hot & develop a knock inside the motor
What would make a 2.5L engine knock on a 1991 Pontiac Grand Am?
It's not a bug, it's a feature.
Where is the knock sensor on a 1991 Grand Prix?
There is two knock sensors on this engine, one is on the engine block closest to the firewall below the spark plugs, the other one is on the opposite side of the engine block closest to the front of the vehicle beside the oil filter.
Why does the when engine knock when accelerating your 1993 Mercury Grand Marquis?
Because you are about to throw a rod. You need to find a mechanic quick!
Where is the knock sensors 2003 Pontiac grand prix?
The knock sensors on a 2003 Pontiac Grand Prix are located on the engine block, typically near the oil pan. Specifically, for the 3.1L engine, one sensor is usually found on the lower part of the engine, while for the 3.8L engine, there are two sensors located on the sides of the engine block. Accessing them often requires removing some components for better visibility.
Does the engine on a 2003 impala knock in the top of the motor if the knock sensor is bad?
The knock sensor just advances and retards the engine timing only. If there is a noise in the engine then you have engine are valve train problems. The knock sensor will not make the engine knock.
Where is the knock sensor on a 1996 4.0 Jeep Cherokee?
The knock sensor on a 1996 Jeep Cherokee with a 4.0-liter engine is located on the engine block, specifically on the passenger side, near the rear of the engine. It is mounted to the block with a single bolt and has an electrical connector attached to it. To access it, you may need to remove some components, such as the air intake or other surrounding parts. Always consult a repair manual for specific details and diagrams for your vehicle.
How does a modern engine management with a knock control system react to engine knock?
This is controlled by a knock sensor.
