bad bain bering
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
Cold engine knock that goes away after warmup is usually piston slap. Worn pistons worn cylinder bores, wrong oil (too light) on a high mileage engine.
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
You should check your motor mounts
The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
Yes , one of Ford's websites lists a knock sensor for the 3.4 liter SHO engine in a 1997 Ford Taurus
The engine computer is the voltage regulator in a 1997 Jeep Grand Cherokee.
You can find the knock sensor on the top side of the engine under the intake manifold. It is easiest to find from the driver's side and is at the back of the engine block.
i have a 2000 ford expedition with a 4.6 in it,i had ENGINE KNOCK AND WAS TOLD IT WAS A SPUN BEARING ON THE CRANK SHAFT,UPON ALITTLE MORE DIGGING I FOUND THAT THE RETAINER CLIP ON THE LIFTER HAD POPPED OFF AND BENT THE PUSH ROD AND THE ROCKER ARM.ALOT CHEAPER THAN A SPUN BEARING
It is located underneath the engine, near the intake manifold. The engine will have to be lifted up for it to be removed.
I had a 1997 2.5 GT. It was on the top of the engine block, towards the firewall, but you had to remove some of the air intake system at the top of the engine to see it.
center of the engine near the top. It is going to be by the heads.