answersLogoWhite

0

Yes , one of Ford's websites lists a knock sensor for the 3.4 liter SHO

engine in a 1997 Ford Taurus

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Knock sensor for a 2001 Ford Taurus?

where is a knock sensor located for a 2001 Ford Taurus se


Where is the 1992 Ford Taurus knock sensor located?

The 1992 Ford Taurus is not equipped with a knock sensor. The Ford Motor Company has been producing the Taurus since 1985.


Where it's the knock sensor located on 91 Ford Taurus?

If it's the Vulcan engine, it doesn't have one


Where is the knock sensor on a 1999 Ford Taurus?

the knock sensor is located toward the front of the engine block and it"s only used on ohc v6 engines. good luck!


Does 1997 ford ranger 2.3 have a knock sensor?

Yes, there is a knock sensor on the 2.3L. It is located on the rear driver's side of the cylinder head.


What causes the speedometer to be intermittent on a 1997 Ford Taurus and how is it fixed?

Have the speed sensor replaced.


Where is the shift module on a 1997 Ford Taurus?

were is the shift module on a 1997 Ford Taurus


Where is the transmission sensor located on 2005 Ford Taurus?

where is the transmission speed sensor located on a 2005 ford taurus


Is there a TPS sensor on a 2004 Ford Taurus SES?

yes there is 2004 Ford Taurus Throttle Position Sensor - Partstrain.com


What is wiper blade size of 1997 Ford Taurus?

there it is http://mywiperblades.com/1997-ford-taurus-wipers.htm


Where is the knock sensor on a 4x4 1991 Ford Explorer?

There is no "knock sensor" on a 4.0L engine


How do you replace knock sensor on a 2007 Ford Taurus 3.0?

To replace the knock sensor on a 2007 Ford Taurus 3.0, first, disconnect the negative battery terminal to avoid any electrical issues. Locate the knock sensor, which is typically found on the engine block, and remove the electrical connector. Unscrew the old sensor using a socket wrench, then install the new sensor by reversing the steps: screw it in place, reconnect the electrical connector, and finally reconnect the battery terminal. Always ensure to check for any leaks or issues after installation.