The Daytime Running Lights module (DRL) is located behind and below the radio in all Gen 1 Neons (at least the Canadian versions). Remove the console faceplate by just pulling it off. Remove the Radio with a 10 mm socket. You may be able to continue without unplugging the radio, but it's easier to access if you do.
The DRL is bolted on an angle to the lower rear of where the radio sits. The unit is housed in a metal case. Two 10 mm bolts also hold it in place, you will be easily able to see the left hand one.. the right will be more difficult. Both can be accessed by inserting your 10 mm socket on and extension through the bolt access holes under the radio housing. Be careful not to lose the bolts when you've released them, as fishing them out from the shifter console will be annoying at best!
The DRL is connected by one large rectangular connector... it just unclips and pulls off. You will lose your daytime running lights and High Beam indicator once removed, however all other headlight functions will remain.
Latitude: 49.88333 Longitude: -97.16667 Latitude (DMS): 49° 52' 60 N Longitude (DMS): 97° 10' 0 W
Chilli peppers
1 kg = 2.2 pounds 97 pounds = 97/2.2 kg 97 pounds = 43.9984599 kilograms
97 times 25 is equal to 2425.
97 degrees Fahrenheit = 36.11 degrees Celsius
Diode or module??? the module is under the dash straight back from the gas pedal..
I believe that is a defective DRL module
If you mean the sensor it is on top of the dash in the middle closest to the windshield, it's a little globe looking thing.
Where is the ignition module 97 explorer
in the mountns of France all over France and around the town of chilcomption
open the fuse panel to expose the fuses. If there is a location guide or chart of fuses, remove the one labeled "drl." If there is no chart, look in the owners manual, it is listed with a diagram. I have found this to be the easiest way on a 97 model. On a 97 there is two fuses that control drl, one is a shared fuse and one is only drl. Make sure you pull the one that is strictly drl if yours has it.
The easiest way to bypass the antitheft module in your 1997 Buick Skylark is to remove the fuse. The location of the antitheft module fuse is listed on the inside cover of the fuse box.
The body control module on a 1997 Chrysler Town and Country is mounted to the back side of the under dash fuse box.
AnswerIt's located on the firewall behind the windshield washer container.Actually, mine is located immediatelly under the Drver's side dash board to the left of the steering column.It is a White and black box about 2 1/2 by 3 1/2 by 1 inch. resting on top of a steel plate held down by one screw.Have fun :)
There is no difference. Both the Neon and Eagle Talon ESI share the same 420A motor.
R-134.