Want this question answered?
99 jeep Cherokee Laredo stay running after turn off the ignition switch?
you take it to the dealer caz you cant do it for sure its incredably complicated
How to change the brake switch on a 2004 Jeep grand Cherokee Laredo
In my case it was the ignition switch itself had overheated and seized up. Replace the switch (have to lower the column, disconnect the wiring plug from the switch, and remove/replace the switch.) Clean all connections to the switch, make sure they're connected solidly and not heating up again.
It is not equipped with a fuel switch.
No.
The fog lamps are activated on a 2000 Grand Cherokee via the headlight switch. Pull the END of the lever OUT.
Yes, the ignition switch must be in the ignition position -not- the accessory position.
When you think there is a possibility you might get stuck if you don't
Jeep does not use inertia/reset switches.
If your looking for an inertia switch, it doesn't have one.
The 1988 Jeep Cherokee fuel pump relay switch is located on the firewall in the engine compartment. The switch will be on the drivers side of the firewall.