I don't know about a Grand Cherokee, but in a 2005 Jeep Wrangler you turn your ignition 3 times with out turning the motor over. Turn your key to start, then off, then start, then off, then start and leave in start position, a code will be displayed in the odometer area. Maybe its the same for a Grand Cherokee. If that doesn't work a scan tool is required.
turn the key
No, you cannot turn of the 4x4
To turn the engine over.
1996 jeep grand Cherokee makes loud clicking noise when turning steering left
what number is the fuse on a 2002 garnd cherokee and where is it located
The lights on your 98 Grand Cherokee are designed to turn off when you start the vehicle. This is how they are made. Once the doors and closed and the ignition is turned on, they turn off.
Try replacing the turn signal flasher
To replace a turn signal on a 1994 Jeep Grand Cherokee prop the hood open. Locate the headlight housing and the turn signal will be located next to it. Find the bulb and remove it from the housing. Replace the bulb.
That is the turn signal switch.
turn the key in the door lock
If your 2002 Grand Cherokee turn signal will not work, it is a good idea to check the fuses first. Then, check the bulb in the signal to see if that is lighting at all. Replace the fuse if it is blown.
The turn signal switch is on the left side of the steering column.
This link should help. http://www.jeepforum.com/forum/f140/how-2005-2009-grand-cherokee-wk-fog-light-install-867728/
Turn it counter clockwise with a filter wrench.
Does it turn over? Does it have fuel, spark and compression?
I don't believe there is a relay. When you turn on the power to your radio the antenna should go up and down when you turn off the power. If the antenna is not doing just that, then the antenna motor is bad.
you just hold the head light stick turn it clockwise one turn and then puul it to out side
Push in and turn it counterclockwise.
Bad crank position sensor
well sometimes it can be because of the computer doesnt recieve signal
turn counter clockwise.
The light is on do to a malfunction in the system. The problem will need to be fixed for the light to turn off.