answersLogoWhite

0


Best Answer

you need to take it too the company you bourght it from because it might b hazardus to you and other drivers

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 99 Honda passport 4wd you put the vehicle into 4wd and the shifter pops out of gear4wd hi-lo when you went to disengage the 4wd button it just flashes and does not disengage?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the proper shifting technique for a semi-auto trans in a classic bug?

1. Accelerate as normal to shift point. (As marked on speedometer.) 2. Place hand on shifter and shift to desired gear. (DO NOT REST YOUR HAND ON SHIFTER at any other time AS THIS WILL DISENGAGE TRANSMISSION FOR SHIFTING. if the shifter is properly wired up, any presure on the shifter will disengage the transmission.) I changed my 1968 Bug from an auto stick to manual because of this.


How do you release shifter from parking on 2001 Mercedes clk 430?

you remove shifter knob, key on, slighty pull back on lever and lightly rap top of shift lever with soft faced mallet, this will disengage park but you nstill have a problem with shifter or possible brake light switch


What does it mean when the OD Off light is on in a 1984 Vovlo Wagon?

OD= Overdrive. There will be a switch to engage/disengage the OD located on the shifter, or on the console in close proximity to the shift lever. It should even have a marking on it.


How do you remove shifter linkage 2000 Pontiac Sunfire immediately following the linkage coming from the transmission block?

Depending on your engine in the 2.4 the cable is behind the filler cap for automatic transmittion fluid. then it goes all the ay down the firewall and into the shifter inside the car need to lift up the leather cover under the shifter and the hand brake as well and the you will see the bublle like conector. disengage both and put the replacement cable .


What does it mean when the shift light flashes and the car won't go?

my car does this every once in a while , put shifter in low and press down on the gas peddle if car still won't move light a match and burn it....


What does the shifter cable do?

The shifter cable connects the shifter to the transmission.


How do you stop the Over Drive Light from flashing at all times in a 91 Lexus ES 250?

dude flashing o/d means problems to your trans check it out No it doesnt. I own a 90 es250 and the o/d flashes when the car is in o/d. There is a small button on the back of the shifter where you can turn it on and off. You might want to look for this button elsewhere if it is not on your shifter.


On a 1998 Regal GS in colder weather the shifter lock does not easily disengage to release the shifter out of park- Is there an easy fix for this other than disabling it?

I have a 2000 buick regal LS I recently found out there is an override for the gear shift, mine is located on the steering column under the steering wheel. There is a small plastic cap, pop it off, then use a screw driver press the button. This worked for me. Good Luck


1996 Town car shifter pin?

broken shifter on colum how do I locate the shifter pin


Oldsmobile Hurst lighting rod floor shifter what is that?

Automatic Floor Shifter - 25 results like the 6423 Shifter Automatic, B & M 81011 Street Rod Shifter Auto Trans Shifter Kits, 3160009 Quarter Stick Shifter ...


How do you take the Honda Passport out of four wheel drive?

Depending on the year... we have a 95 and to take it out we have to stop, put the 4wd shifter into neutral and then back up 15 feet or so. You should be able to feel the difference when turning.


How do you disengage 4 wheel drive in Isuzu Rodeo?

Place the truck into nutral, push the 2H shifter into the 4H position and then put the car into reverse and back up about 12-15 feet. After doing so the clutche in each of the front hubs will be locked in. If you have manual locking hubs you will nedd to get out of the vehicle and lock them in manualy, and then repeat the procedure above. To disengage the hubs repeat the same procedure only in reverse (Pull the lever back into 2H).