On the 2.4L engine,Remove the belt,remove the Altenator,take out the 1 bolt holding it to the block. take off the 2 bolts holding the top of the a/c compressor to the tentioner.Lift and wiggle it strait up. "poof" It's off.
Note:The drivebelt routing decal on the radiator shroud to help during drivebelt install * To replace the belt rotate the tensioner pulley clockwise to release belt tension * Remove the belt from the auxiliary components and slowly release the tensioner * Route the new belt over the various pulleys again rotating the tensioner to allow the belt to be installed then release the belt tensioner
A 1999 Cavalier does not use Freon as a refrigerant.
What about this tensioner? How do you remove it, or how do you releave the tension so you can replace the belt?
where do i find the thermostat for 99 cavalier
The flasher for a 99 Cavalier is under the drivers side of the dash. The flasher is mounted at the top of the emergency brake pedal.
you can as long as it is withing certain years 1996-1999 cavalier engine will work in a 96-99 sunfire and a 99-02 cav engine will fit a 99-02 sunfire
It is likely that your fuel sending unit has gone bad. It is located in the fuel tank. Some tanks have an access hole and others require the removal of the fuel tank to replace it.
No...the 99 has 2 bulbs and the 01 has 1 bulb
most body and interior parts should be the same. Engines are different.
you dont,the tensioner tightens the belt up.if belt sqeals get new belt or tensioner! on 3.1v6,
unbolt it
30 mpg hwy