you dont,the tensioner tightens the belt up.if belt sqeals get new belt or tensioner! on 3.1v6,
Remove the drivers side wheel. Remove the inner cover. Taking an Allen wrench and tighten the tension roller against the belt.
It's on the center of the idler pulley
This is a procedure that requires specialized equipment. Take it to a dealer and have it done correctly. This is not a DIY job.
I am 99% positive that your Malibu does not have a cam belt, but instead has a cam chain. Look in your owner's manual or call your local Chevy dealer to be 100% sure.
What about this tensioner? How do you remove it, or how do you releave the tension so you can replace the belt?
Yes, there are bleeder valves for cooling systems for 99 Malibu.
Loosen the bolts on the pump to allow the belt to lose tension. Remove the belt, then put on the new belt. Pull the pump to tighten the belt snug but not over tight while tightening the bolts.
On top of the engine there is a serpentine belt (5 grooves). The tension is autmatically set by the belt tensioner. It is an arm with a pulley on the end of it. The other end has a 3/8 inch connector for a ratchet. Put a ratchet on the end of it and pull it towards you. This should relieve the tension enough to take the belt off the pulleys.
To check the fan relays on the 99 Malibu, you can swap the relay between the AC blower and the fan.
marks timing chain 99 Malibu 2.4
i have a 99 Malibu and it takes about 5 and a half quarts to fill!! hope this helps!!!i have a 99 Malibu and it takes about 5 and a half quarts! hope this helps!!
Were is locate the snock sensor of chevi malibu 99