Want this question answered?
Inside the circuit loop between the inductor and capacitor the current will be at maximum. Outside the circuit the current through the LC tank circuit will be at minimum. It depends on where you are measuring it.
Holding current is a kind of Imin i.e., a minimum rating current which should not be decreased less than this limit so that SCR will be off(Maximum limit).Whereas latching current is again a limit which is Imini.e., a minimum current that should be there to make it on(Minimum limit).So obviously Holding current is more than latching current.If u still have the confusion go through the link below ALi RAZA
Minimum and maximum
It depends of your panel ratings. usualy, a panel short-circuited has a maximum current, you can base the value on that. But if you are doing an array of panels, you have to pai attention to the parallel connection, once that multiplies the current across the circuit. in this case you have to use diodes that support the current of the array.
maximum spacing assording to IS 456 = 300mm
The minimum and maximum possible value is defined by the tolerance. To calculate the range of the resistor, simply add or remove the amount of the tolerance. For example, a 100Kohm resistor with 5% tolerance can range from 95Kohm through until 105Kohm. The lower the tolerance, the more accurate the resistor is.
It is a variable resistor. Basically, the same as when you turn up or down the heat on an electrical oven or radio.
Inside the circuit loop between the inductor and capacitor the current will be at maximum. Outside the circuit the current through the LC tank circuit will be at minimum. It depends on where you are measuring it.
The minimum, maximum, and current temperature.
NO i got it right on e2020 its no
The extrema are the maximum and minimum values.The extrema are the maximum and minimum values.The extrema are the maximum and minimum values.The extrema are the maximum and minimum values.
The opposite of minimum is maximum.
For a particular frequency if the current or the voltage of the circuit is Maximum or Minimum then that circuit is said to be in resonance .
Maximum:
A parabola's maximum or minimum is its vertex.
Minimum-Maximum was created in 2005-06.
The hFe (current gain) on the BC148 ranges from a minimum value of 20 to 100, depending on collector current, with a maximum value of 300.