False
cable modem - A technologythat uses cable TV lines for data transmission
Utilities, when referred to in relation to easement rights in real property consist of such services as electric and telephone transmission lines, cable service lines, gas transmission lines, water and sewer lines, etc. When used in regards to a rental unit or costs to maintain a property, utilities refers to the various monthly charges for those services.
Transmission lines are thicker than TV cable wires because the transmission lines are used to transmit both low freq and high freq signals. And the losses of the transmission lines depend the resistance of the line which inturn depend upon length and area. As we have to transmitt the signals over long distances the transmission lines are thicker in size.Whereas in TV cable wires the construction is totally different in which transmission of signals is in between two conductors thereby avoiding losses.Therefore there is no necessity for these lines to be made thicker. That is why transmission lines are thicker than TV cable wires.
336 776 and 795
connection of the ground of all the transmission lines and used as a communication cable between protection devices
Transmission lines are three-phase systems. There are three line conductors in a three-phase system. However, to reduce electric stress at higher voltages, these lines are frequently made up of 'bundled' conductors -so each line might have two, three, or four separate conductors. In addition, transmission towers usually carry separate circuits -i.e. separate three-phase circuits on opposite sides of each tower. So, in the UK for example, a typical 400-kV transmission line will consist of two, separate, three-phase circuits suspended on each side of each tower, with each line consisting of four bundled conductors. That's 24 conductors.
ACSR - Aluminum Cable Steel Reinforced
To reduce the electric field intensity at the surface of the conductor which can lead to corona discharge and insulation breakdown. By using bundled conductors, the electric field is distributed between the four (in the case of 400-kV lines) conductors, thus reducing the field intensity per conductor.
High-voltage transmission line conductors are 'bundled' -that is, each 'line' comprises two or more conductors, rather than a single conductor, suspended from each insulator chain. The reason for bundling is to reduce the intensity of the electric field on the surface of the conductors (the same field is shared between the surfaces of several, rather than just one, conductors), which would otherwise result in a breakdown of the insulating property of the air immediately surrounding a single conductor. In the UK, 400-kV transmission lines use a bundle of four conductors per line, and 275-kV transmission lines use a bundle of two.
You can disconnect the 1996 Jeep transmission lines with a 9/16 open end wrench. Be prepared for transmission fluid to come out of the transmission lines.
if you are asking about the cooling lines for the transmission that connect to the radiator, its easy. first disconnect the lines from the radiator (2 lines, usually on the bottom opposite the radiator outlet) then disconnect the lines from the transmission. remove the brackets holding them on, then remove.
T1 line