The volume of the combustion chamber?
(2000 cc / 4) / 10 = 50 cc per chamber
Depends on why there is no compression.
The compression ratio of an internal-combustion engine, or an IC engine as it is more commonly called, is the ratio of the volume the highest capacity of the combustion chamber to its lowest capacity. In the IC engine, the piston makes a stroke, resulting in the compression of the air in the combustion chamber - the ratio between the volume of the cylinder and combustion chamber when the piston is at the bottom of its stroke, and the volume of the combustion chamber when the piston is at the top of its stroke, is the compression ratio.
With a compression gauge.
an engine may have more than one cylinder. if a 4 cylinder engine has a displacement of 2.2 L, then each cylinder is 1/4 th of that or 0.55 L per cylinder.
When it was new it had 150 PSI. per cylinder
Compression ratio is exclusive to each cylinder, though they will all have the same result if they are the same dimensionally ( and they always are) > Divide the total engine capacity by the number of cylinders, this gives the capacity or swept volume of each cylinder (bore * stroke) > So in a 2.0 (2000 cc) litre 4 cylinder engine, each cylinder has a 2000 / 4 = 500 cc swept volume (bore * stroke) > The combustion chamber is the volume remaining at top dead centre (TDC) > Compression ratio = volume at BDC (swept volume + volume at TDC) / volume at TDC
Engine cylinder capacity(Engine cylinder volume )is represented by cubic centimeter(cc).CC is calculated by the following formula CC=N*((π*d^2*l)/4) N=no.of cylinder d=cylinder dia l =stroke length
On your Ford Ranger with the 2.3 or 2.5 liter four cylinder engine , with Fords twin plug ignition system : The compression plugs are on the DRIVERS side of the engine
The compression ratio of engines is a value that demonstrates or shows the ratio of the volume of its combustion chamber from its largest capacity to its smallest capacity.
I assume you mean engine displacement? To calculate engine displacement, use this formula: Bore x bore x stroke x .7854 x number of cylinders.
You may have compression on any cylinder where the valves happen to be closed, but you will not have compression on all cylinders. 1991 Sable does not have a 305 engine.
Just did compression test on mine and the normal seems to be 160 -180