A 5 percent tolerance resistor would only have two significant digits in its stated value, so we are talking about 82000 ohms plus or minus 5%. The coloured bands would be grey (8), red (2), orange (times 1000), and gold (5%).
6.67%
Yes, that looks right.
The color bands show the nominal resistance. The actual resistance is within some percentage (tolerance) of the nominal resistance, so the measured resistance is close to the nominal but not exactly the same. Also resistance varies with factors like temperature and age of the device.
brown, red, brown, silver = 120 ohms
red 2, black 0, red 102, red 2%. 20 x 102 with 2% tol.
6.67%
A 1 ohm 20% tolerance resistor should not exceed 1.2 ohms actual resistance.
Percent
red-violet-yellow-gold
Yes, that looks right.
On a standard four band resistor: yellow, violet, black, and gold.
The color bands show the nominal resistance. The actual resistance is within some percentage (tolerance) of the nominal resistance, so the measured resistance is close to the nominal but not exactly the same. Also resistance varies with factors like temperature and age of the device.
brown, red, brown, silver = 120 ohms
It indicates how close the real resistance of the real resistor is guaranteed to be to the numbers indicated by the first three bands. Gold . . . within 5 percent higher or lower Silver . . . within 10 percent higher or lower No 4th band . . . within 20 percent higher or lower
It indicates how close the real resistance of the real resistor is guaranteed to be to the numbers indicated by the first three bands. Gold . . . within 5 percent higher or lower Silver . . . within 10 percent higher or lower No 4th band . . . within 20 percent higher or lower
red 2, black 0, red 102, red 2%. 20 x 102 with 2% tol.
count up the value of the resistor using the colour bands along with resistor code chart(or it may on the resistor eg. 10kohms, follow this by hooking up an ohm meter(you will have to select ohms, kilo-ohms, mega-ohms whichever applies) , your resistance should appear within the acceptable variable guidelines.. usually 5 to 10 percent(last band or on the resistor itself) count up the value of the resistor using the colour bands along with resistor code chart(or it may on the resistor eg. 10kohms, follow this by hooking up an ohm meter(you will have to select ohms, kilo-ohms, mega-ohms whichever applies) , your resistance should appear within the acceptable variable guidelines.. usually 5 to 10 percent(last band or on the resistor itself)