0
A solid circular steel shaft is subject to torque of 1 knm what should the diameter of the shaft be if the maximum shear stress is to be 70 MPa?
Wiki User
∙ 15y ago
S=16T/pi()d^3 70N/mm^2=16*(1 x 10^6 N-mm)/(pi()*d^3) d = 41.75mm
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the maximum allowable minor diameter for M6x1.0 interenal threads?
the minor diameter should fall between 4.917mm - 5.153mm
How many cubic inches in a dish that is 12' by 7.5'?
A third dimention is required. Or if it is a circular dish then the diameter or radius should be stated
How do you know if your rear drums need replacing?
Brake drums should not be turned beyond a maximum diameter, usually stamped on the drum face. Machining them above the maximum tolerance would subject them to overheating and possible brake failure. Better to replace them with new drums & shoes.
How many people can sit round a 4' diameter table?
A 4' diameter table will have a circumference of ~12.5'. Assuming each person takes up just a little bit above 2', there should be enough room for a maximum of 6 people.
Picture of 1999 Dodge Durango distributor cap?
it's a black circular piece of placstic. about the diameter or an orange, there should be wires running to it. if you pull a wire off there should be a piece of metal that looks like the end of a spark plug sticking out. that is it!
How often should I sharpen the blade on my circular saw?
It is recommended that you should sharpen your circular saw about once a year. However if you are a heavy user of your circular saw then you should sharpen once every six months.
Why should the orbit be circular?
Orbits sould be circular because the centripetal force that keeps objects in circular motion is constant (it is gravity!)
What is the significance of stepped core?
A transformer's windings are pre-wound around insulated 'formers' or tubes of circular cross section. To achieve maximum flux density, the core should ideally be of circular cross-section, too. A 'stepped core', then, describes the way in which the widths of the outer laminations of a transformer's core are progressively reduced ('stepped') in order to achieve a roughly-circular cross-section.
What is the significance of CORE?
A transformer's windings are pre-wound around insulated 'formers' or tubes of circular cross section. To achieve maximum flux density, the core should ideally be of circular cross-section, too. A 'stepped core', then, describes the way in which the widths of the outer laminations of a transformer's core are progressively reduced ('stepped') in order to achieve a roughly-circular cross-section.
What is the diameter of a circle that has a circumfrance of 21.98m?
The diameter should be 7m.
Should Co-Circular Activities be made compulsory?
co circular activities should made compulsory because they keeps your mind fresh and healthy
A subway track must pass through a cylindrical tunnel The tunnel is 6 m in diameter How wide should the track bed be so that the maximum height at the centre of the tracks is 4.5 m?
2.6m
