0
A technician has installed a new video card and the computer will now only boot into VGA mode What would be the may be the cause of the problem?
Wiki User
∙ 12y ago
The new card is not dvi compatible
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
A technician fails to successfully boot a computer into Safe Mode The technician then successfully boots the computer using a Windows boot disk What is the most likely cause of the problem?
hard drive failure
While troubleshooting a computer a technician notices that the computer will not boot normally but it can boot into Safe Mode What is the most likely cause of the problem?
A driver
How can a technician verify the cause of a problem?
By fixing the problem!
How would the technician verify the cause of the problem?
verify the cause by testing the sample
How would the technician verify the cause of problem?
verify the cause by testing the sample
Which problem could occur if a screwdriver is used to pry the top off of a computer case?
The screwdriver could slip and cause harm to the technician or to nearby individuals.
Will bulkhead connectors make your 1999 dodge ram die and give a no bus signal?
Any computer or a wiring problem ( connectors included ) can cause that problem.Any computer or a wiring problem ( connectors included ) can cause that problem.
A second hard disk drive was recently installed not being reconized by the system All the cables and jumber settings are in order what can the technician do to locate the cause of this problem?
Verify that the BIOS has been configured to detect a second hard disk drive
What happens when you have a hard drive problem?
You will have a big problem. You could lose files and cause internal computer problems
What is the most common problem of a computer?
The user is the most common problem and most common cause of other problems.
What are user applications?
The ones that are not a part of the operating system and their absence may not cause a problem. Usually the user has installed them but the ones installed by PC manufacturers can be called user application too.
What two actions should the technician take if the testing did not identify an exact cause?
Establish a new theory of probable causes. document correct the problem.
