Their is no 1993 olds alero the first year is the 1999 sorry.
Looking at the top of the valve cover there is a cover in the center. The spark plugs are right below that cover.
on a 2002 olds alero 2.2 4 cylinder ecotec the spark plugs are located on top of the intake, under the cover that gives the engine size,it is possible that yours may also be located under this cover. All you have to do is remove the four bolts on top of the cover and your plugs will be under there.
For the 2.2 engine:ACDELCO Part # 41105 For the 3.4 engine:ACDELCO Part # 41101
if its a quad 4 engine, you must remove the top engine cover to reveal ignition assembly. not a cheap part to replace. replace plugs only when misfiring.
what is the spark plug gap for a 2004 oldsmobil alero 3.4 eng
replace a water pump on a 2004 olds alero 2.2 litler
alero intake manifold torque specs
They are attached to the end of the HT leads.
theres no 93 olds alero
You need to replace the motor
oil on the spark plugs is generally due to broken ring or rings in the cylinder or cylinders can also lead to a blown engine
diesling is caused by bad spark plugs
for each cylinder there is one plug youll see the wires leading to each Improved Answer: I have a '98 Olds and it is a V8 meaning it has 8 plugs
the three coil packs are located above the rear rocker cover, near the firewall. -- In the way to replace the spark plugs.
Are parts interchangable from a 1999 alero to a 2001 alero
Oldsmobile stopped making Alero in 2004 and GM stopped making Oldsmobile in 2004, so some mistake here?
Use a sparkplug socket and turn counter clockwise
Use silicon grease.
how to get the check oil light to go off on a 2001 olds alero
The factory made the Olds Alero do that, I have a 2001 Olds Alero and it does the same thing. It's just a factory thing that they have done to the car.
To replace the timing chain on a 2.4L olds Alero you need to remove many parts. The parts that need to be removed are the drain coolant, the alternator, the air conditioning compressor, the water pump, and the harmonic balance. Once these parts are removed, you will need an engine hoist to lift the engine.
I have a 1991 Cutlass Supreme and I had to use a flex ratchet to replace the back 3 plugs. Other than that I was told by a mechanic friend that the motor has to come out to do this.
Try replacing the plugs and wires