You will need a 1/2" wrench. If you lay on the ground behind the mower and look underneath it on the right side of the rearend toward the front is an arm that comes from the front that attaches to a lever on the rearend. Where this lever pivots is the adjustment for the brake. You should be able to slowly tighten that nut until the brake drags when you push the mower back and forward. Once it drags just back it off a 1/4 turn and you should be OK. This should only take 5 minutes or less. The problem you may have is that after these brakes haven't been used in a long time they tend to freeze up. Once you adjust it and the brakes apply the first time you might have a hard time getting them to release. Many times I have had to take the brake system off of the rearend to free up the pistons in the housing. So, be aware that this might happen and allow extra time.
There could be many reasons why your Sears riding lawn mower won' shut off. The key could be jammed for example.
1995
Go to managemylife.com.
One can purchase a Craftsman riding lawnmower from Sears, direct from Craftsman, or at the website of TractorByNet. One may also be able to purchase a Craftsman riding mower on eBay.
If there is a blown fuse on a Sears riding lawnmower, the fuse box is located below the seat. It is not common for a riding lawnmower to blow a fuse so there could be another cause like a short in the wiring.
try a company called Grasshopper. they are near chelmsford,Essex.
i changed the belt on my 42' craftsman riding mower, belt route is right but may belt is burning up. I don't know if my levers are connected right.
It was made in late 2001 for the 2002 model year
1997 /But the engine has been replaced with #694199 Short Block 2004
Contact Sears or check their web site.
I would guess that it is actually a Poulan. They are marketed under their name and I believe most or all Sears Craftsman riding mowers are actually manufactured by them.
what kind of oil for a sears push mower and how much?