1. initial cost is low
2. reduce the loss by reducing the resistance
Consumer circuit is a circuit that fixed between distribution line and consumer load control and protection unit is attached in order to prevent overload, leakage and short circuit.
Air-blast circuit breakers are used to disconnect high-voltage transmission or distribution circuits in the event of a fault. One circuit breaker is required for each of the three line conductors; there is not normally a neutral conductor in high-voltage three-phase transmission/distribution lines.
to complete the circuit and back to power supply
A double pole double throw transfer switch is what you are referring to. It does not go on the house meter. The placement of the transfer switch is between the first over current device and the distribution panel.
it is the natural commutation ...by making open circuit or short circuit on the thyristor to make it turn off.
Double Circuit Double Circuit String Transmission Line
Double circuits can carry more power. Also, double circuits introduce a level of redundancy, so that if a single circuit (half of the double circuit) fails, the other half is still intact.
To compan
Consumer circuit is a circuit that fixed between distribution line and consumer load control and protection unit is attached in order to prevent overload, leakage and short circuit.
Air-blast circuit breakers are used to disconnect high-voltage transmission or distribution circuits in the event of a fault. One circuit breaker is required for each of the three line conductors; there is not normally a neutral conductor in high-voltage three-phase transmission/distribution lines.
no it no restricted
The single line diagram is circuit diagram where "one-line" is shown to represent three phases of a three phase power system. In addition to showing the ratings and size of electrical equipment and circuit conductors, a properly drawn one-line diagram will also show an electrically correct distribution of power with respect to current flow from the power source to the downstream loads or panelboards.
to complete the circuit and back to power supply
min 18 mtr tower used or ground clearance maintain as IE rule for 220kv transmission line Rakesh vishwakarma
Yes, an open in main line of a parallel circuit will effect the entire circuit current and make the whole circuit current zero
it is nothing
Distribution lines