There are no Advantages. They will pull out and then things brake NOT GOOD
Screew in studs are the way to go, They stay put.
press studs were around and used a lot as boot stated in the 1890
Mr press Stud
The press-in studs are on the cylinder heads. That's where the rocker arms go. Press-in studs don't stay in very well in high performance applications, so most people either have there heads machined to accept screw-in studs, or buy heads that came with screw-in studs. A low-cost alternative to screw-in studs is to have the press-in studs cross drilled to accept roll pins to keep them from pulling out of the pedestals. This only applies to iron heads, as aluminum heads always come with screw-in studs.
You can get more insulation when using 2x6 studs rather than 2x4 studs
Press studs are machine washable safe. They are a good components for fastenings - quick and easy to open and close. Sorry, it's not a great answer but I hope it helped!
Unbolt hub and press out wheel studs, clean hub face, replace rotor and press wheel studs back through, remount hub
there are both screw in and press in studs on 350s. it depends on application. i will say that fatory heads are most likely press in. high performance applications may be screw in.
Compare the advantages of Turret punch press and conventional punch press
Front studs on a 1999 Honda Accord are pressed in. First the studs must be removed using a hammer or press. Once remove each stud can be pressed in.
Lug studs on a 1994 Acura Integra is pressed into the hub. To remove the lug studs safely raise and prop the car. Remove the wheel, brake components, and suspension parts from the hub. Press out the old studs.
You could press in a new, oversize stud, cross drill and pin the stud, or have the head machined for screw-in studs.
To remove wheel studs from a 2000 Honda Civic the wheel needs to be removed. Taking the wheel hub completely off the vehicle makes the process of removing the studs easier. The studs are pressed in and use of a machine press to remove them is recommended.