0
Air is only coming out of defrost vents no matter what setting air conditioner is on in my 98 Dodge Intrepid.?
Wiki User
∙ 15y ago
Sounds like the switch broke (the one that directs the air valve) or disconnected somewhere along the shaft.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Why is your air conditioner only coming out of the defrost in the car?
It have battery
Why does my Ford F-250 air conditioner switch back and forth from panel to defrost on its own?
it works off of vacuum. check the lines coming from the vac pump under the hood for dry rot or cracks
What is wrong when the air conditioner on a 1989 Oldsmobile 98 regency blows out the top and not through the vents?
Could be a vacuum problem--either broken or disconnected hose or bad vacuum motor under dash or coming in through firewall Defrost is the default position for this system
What Bad smell is coming from my defrost in my 98 f-150?
the heater core is going out
Why is smoke coming from your defrost vent?
The most common thing will be that you have a leaking heater core...........
Why water is coming out of split air conditioner unit?
That is condensation and it is normal for water to come out of an air conditioner in the back of it.
What are the signs of a broken heater core?
usually you will get antifreeze smell and steam inside coming from defrost
Smell coming from reverse cycle air conditioner?
A smell coming from a reverse cycle air conditioner may be a signal that the filter needs to be cleaned. A smell like engine exhaust might be present if the air conditioner motor is in need of repair.
Why do you get hot air blowing out your air conditioner?
I get hot air coming out of my air conditioner on the passenger side, while I get cold air coming out the drivers side. Can you tell me why and how do I find the schematic to fix it?
Why is fog coming from car vent?
The air conditioner is low on refrigerant.
Why is check engine light coming on your Dodge Intrepid?
You may need to replace the power control module.
Your 93 intrepid goes into limp mode only when coming to a stop?
You need to have the faults in the transmission read.
