0
I do believe that both have a 2.0 engine. However, in the 6 years between 1994 and 2000 I'm sure that there have been updates and changes to the block, such as bolt locations for the head, manifolds, engine mounts, accessories that would make the older block unsuitable or incompatible for use in the newer car.
What else can I help you with?
Where is the Ford Focus block heater?
where does the engine block heater go in my 2007 ford focus
Where is the engine block heater cord on a Ford Focus?
The engine block heater cord, on a Ford Focus, is located just below the front grill. The cord will extend out approximately 6 feet.
Where is the block heater of Ford Focus 2013?
The block heater on a 2013 Ford Focus is typically located near the engine, often on the front or side of the engine block. It can be identified as a cord plugged into the engine, usually with a visible electrical connection. If you have difficulty locating it, consult the owner's manual for specific diagrams and details related to your vehicle's configuration.
Where is the engine number on a 2003 Ford Focus?
Stamped on the LHR of the engine block facing the radiator side at gearbox join.
Where is head gasket located on 2000 focus se 2.0?
Sandwiched between the head and engine block.
Where is the temp sensor located on a ford focus 2002?
on the 01 zetec motor it is located below the alt. on the engine block.
Where is the oil filter for 2005 ford focus ZX5?
the oil filter can be found on the underside of the car just to the front of the engine block, roughly along the centerline.
Ford Focus engine?
How do you turn of the engine on a new ford focus
Ford Escort engine fits in a focus?
I bought a 2001 Focus 2.0 SOHC vin P for my daughter with a trashed cylinder head and block. The blocks are slightly different but will work. One of the water pump bolt holes is different and the side of the engine towards the firewall don't have the mounting for the Focus carrier bearing on the Escort block. A bracket support must be fabricated for the carrier bearing of the right drive axle. The Escort crankcase vent must covered since the Focus block is also blank. Focus water pump to Escort block will work you just need to drill one extra hole top left of the block. I found out the cylinder heads doesn't interchange but are both SPIs, head manifold bolt patterns are different. Also the engine mount is connected to the head and also will not work vice versa. The engine to tranny matches perfectly. I used a 98 Escort block to 2001 Focus and the car runs great with these modifications. I just have to keep an eye on the cooling system. As I've read on the internet, overheating is why the valve seats falls off and why I end up with this project. ****************** What you are doing is both illegal and ill-advised. The engines do NOT interchange, since they don't have the same mounting points. It is illegal to install an older engine in a newer car per EPA regulations, as well as an engine that was never installed in a regulated vehicle. In many states this is an automatic emissions fail. Fabricating bearing and engine mounts is not something that should be tackled by an amateur mechanic.
Where is PCV valve on 2005 Ford Focus?
On the drivers side on the engine block. follow the hose that comes from the back of the valve cover. may have to remove intake manifold.
Is a Ford escort short block the same as a Ford Focus?
no, a ford focus is longer
Where is the crankshaft sensor located at on a 2000 ford focus?
On a 2000 Ford Focus, the crankshaft position sensor is typically located near the bottom of the engine, mounted on the engine block or transmission bell housing. It is usually positioned near the crankshaft pulley for accurate detection. To access it, you may need to remove some components, such as the air intake or other engine covers, depending on the specific engine configuration.
