0
Add your answer:
Earn +20 pts
How do you change the spark plugs on a 2000 Chevy Silverado 1500 with a 5.3 liter engine?
I`M HAVING A HARD TIME REMOVING SPARK PLUG WIRES ON MY 2002 CHEVY SILVERADO 2500 6.0. ANY TIPS?
Why is it hard to stop in a 1988 silverado you change the brakes and bleed them?
you change the brakes,check brakes fluid,bleed the brakes why is hard to stop in a 1988 sliverado?
Why does 1998 sun fire ride rough ive change shocks springs?
maybe your tires are too hard
What if you change the power steering pump and the steering wheel is still hard to turn on a 2000 Chevy Silverado?
ball joints could be bad Did you make sure you got all the air out of the power steering system?
Why is a 2000 silverado 5.3 Vortec hard to start and the passenger side of the engine misses when it is started?
A 2000 Silverado 5.3 Vortec that is hard to start and misses on one side of the engine might have a problem with the coil pack or the spark plugs. It could also mean that the block is cracked if the engine is prone to overheating.
Is it hard to change a 2000 Volvo v40 steering rack?
Very hard
How do you change the spark plugs in a 2000 Chevy silverado?
Just twist the plug wire left and right a few times and then pull it off. They are hard to get off. Then get a socket 5/8 deep well socket and take the plugs out. No problem.
How hard is it to change the rear struts on an 2000 dodge neon?
not hard at all,you will need a spring compressor
How do you change shocks on a Honda passport?
Not hard at all. For the rear shocks just crawl under the vehicle, unbolt the shock from the top and bottom, pull it out, and replace it. For the front it's about the same, only difference is that you'll have to jack it up and remove the tires to get to them.
Nissan Maxima fuel filter change?
How hard is it to change a 2000 Nissan maxima fuel filter
Is cutting your front shocks hard?
possibly my front will be bleeding
How do you change shocks on a 97 Honda Passport?
Not hard at all. For the rear shocks just crawl under the vehicle, unbolt the shock from the top and bottom, pull it out, and replace it. For the front it's about the same, only difference is that you'll have to jack it up and remove the tires to get to them.
