the crank pulley bolt has standard threads.
The Crank bolt on a 1989 festiva is just a standard thread. Right to tighten left to loosen. nice and simple. The Crank bolt on a 1989 festiva is just a standard thread. Right to tighten left to loosen. nice and simple.
No,it is right hand thread.
No. They are a normal Righ-Hand thread: 'righty tighty/lefty loosy' :-) The Crank pulley IS very tight (hopefully) upwards of 120/ft-lbs is normal torque. Check http://www.ultimatesubaru.org/forum for info on 'how to ' remove. TD
remove 22mm center bolt its regular thread there are 2 threaded holes in pulley you will need the right pulley remover with the right bolts for the pulley you can get this at most parts stores make sure to not mess up crankshaft bolt threads
In most cases the crank pulley bolts to the balancer so the crank pulley would not be the same as the harmonic balancer.
The crank sensor is located on the front side of the crank pulley, between the pulley and radiator.
There is both a puller tool & installer tool. Some do both. You remove crank bolt & thread rod thru a triangle shaped assy that threads into 3 pulley holes & pushes it off against crank snout,. To install can use bolt & impact hammer or installer that threads into crank bolt hole & you turn a nut to crank it on. Most engine building suppliers have them.
Check the crank shaft pulley
LEFT! Surprisingly the bolt is a normal right-handed thread
Where is the crank pulley located on a 1991 honda civic dx
how to get the crank shaft pulley off of a 03 Hyundai elanta GLS
A video instruction guide on how to check a crank shaft pulley can be seen on YouTube. Just type in "How to check crank shaft pulley", click on Search, then play the first video.