are there any hazards or precautions that should be taken around the element scandium
should be scandium. not sure though
If you mean name of an html element, it should look like this: <element name="element">
Ag (should not be written as ag) is the symbol of the element silver.
A radioactive element is one that discharges radiation. Uranium is a radioactive element. A radioactive element is very dangerous if you don't have protective clothing. You should never go near a radioactive element.
Krypton is one element on the Periodic Table that sounds like it should be in a comic book.
should be scandium. not sure though
Elemental scandium is not considered to be toxic. Little animal testing of scandium compounds has been done.[29] The median lethal dose (LD50) levels for scandium(III) chloride for rats have been determined and were intraperitoneal 4 mg/kg and oral 755 mg/kg.[30] In the light of these results compounds of scandium should be handled as compounds of moderate toxicity. or you can look up "scandium element" and go to wikipedia hope i helped :D
Hazards
I had the swizzbeat for 2 seasons and used the scandium many times just passing around. The two shafts are very similar, my swizzbeat had one noticeable dent in it after 2 years of getting smashed by highschool d-poles, so it's tough. The scandium is actually a little bit stronger because it's reinforced with scandium. But this also makes it a little bit heavier. In my opinion the biggest choice you have to make is which graphic you like better, they both feel really good in your hand. I would say if you're worried about your stick breaking then go with the scandium, if not, go with the swizzle.
state hazards that can be dealt with personally
who should you report this to abouthazards
Element Tech Decks are still around. They are just more how should I put this More More Rare.
Yes, you should, looking ahead for potential hazards is great practice!
Butt
Implement controls
A pillar drill is another name for a drill press. The biggest hazards are objects getting wrapped around the chuck, and debris or projectiles being thrown. So long hair, ties, and loose clothing should be avoided, eye protection should be worn, and your work should be securely clamped to the work area. Other hazards could include drilling oneself, being injured inside the gearbox, or starting a fire. So you should keep all body parts from around the chuck and pulleys while the drill is in operation. You should be careful to not let your work get overly hot, not operate the press in the presence of flammable vapors, and not overload the outlets.
Implement controls